Table of Contents
Advertisement
STEP 1
To ease the assembly process, do not tighten bolts until instructed.
1.Attach the Front Upright (2) to the Base Frame (1) using two 3/8" X 3" Hex Bolts (68), Four 3/8" Washers
(80) and two 3/8" Nylon Nuts (83).
2.Attach the two Rear Uprights (4) and the four Tri Link Plates (18) to the Base Frame (1) as shown, using
two 3/8" X 3" Hex Bolts (68), four 3/8" Washers (80) and two 3/8" Nylon nuts (83). Cap the left and right
sides of the Base Frame (1) with two 50mm X 50mm End Caps (53).
3.Insert four Plastic Guide Rod Holders (57) into the Base Frame (1) and the Top Guide Rod Retainer
welded on the Top Frame (3) as shown. Slide a Rubber Donut (47) onto one end of each Guide Rod (9)
and then insert the Guide Rod (9) into the Plastic Guide Rod Holders (57) in Base Frame (1) as shown.
Slide each 10 lbs Weight Plate (21) over the Guide Rods (9). Make certain that each plate is oriented
with the selector hole on bottom and facing forward. Attach the Selector Rod (23) to the Top Plate (22)
with the Top Plate Bolt (65). Slide the Top Plate (22) and Selector Rod (23) onto the Guide Rods (9).
4.While making sure that
the Guide Rods (9) are
inserted into the holes
the Top Guide Rod
Retainer, attach the Top
Frame (3) to the Front
Upright (2) using two
3/8" X 3-1/8" Hex Bolts
(67), four 3/8" Washers
(80) and two 3/8" Nylon
Nuts (83).
5.Attach the two Rear
Uprights (4) to the Top
Frame (3) using two 3/8"
X 3" Hex Bolts (68), four
3/8" Washers (80) and
two 3/8" Nylon Nuts (83).
Insert 50mm Sq. Plugs
(54) into the Top Frame
(3) and Rear Uprights
(4).
6.Attach the Lat Bar Holder
(20) to the Top Frame (3)
using two 5/16" X 1/2"
Threaded Hex Bolts (73)
and two 5/16" Washers
(81).
Main Frame Assembly
67
80
80
3
54
57
20
81 81
80
80
73
83
83
62
2
80
83
80
80
47
80
68
53
18
80
68
80
68
80
68
1
68
83
80
57
55A
9
22
47
23
57
18
53
80
5
54
80
68
4
80
80
18
18
65
21
46
83
83
80
80
Advertisement
Table of Contents
