Startup Menu (Using Remote Keypad (Hmir)); V/F Control Type (P0202 = 0) - WEG MW500 User Manual

Powering up and Start-up

5.3.2 STARTUP Menu (Using Remote Keypad (HMIR))

The start-up is explained in a very simple way, using the programming features with the
existing parameter groups in the menus STARTUP and BASIC.
After the hardware pre-configuration, the drive will operate with a different control type.

5.3.2.1 V/f Control Type (P0202 = 0)

Seq Indication on the Display / Action
1
Monitoring mode.
„
Press the key ENTER/MENU to enter 1st
„
level of programming mode.
2
The PARAM group is selected, press the
„
keys  or  until selecting the STARTUP
group.
3
When the STARTUP group is selected
„
press the key ENTER/MENU.
4
If necessary, press ENTER/MENU to
„
modify the content of "P0202 – Control
Type" for P0202 = 0 (V/f).
5
When the desired value is reached, press
„
ENTER/MENU to save the modification.
Press the key  for the next parameter.
„
28 | MW500
Figure 5.4: Sequence of the Start-up group for V/f control
Seq Indication on the Display / Action
6
If necessary, modify the content of "P0401 –
„
Motor Rated Current".
Press the key  for the next parameter.
„
7
If necessary, modify the content of "P0402 –
„
Motor Rated Speed".
Press the key  for the next parameter.
„
8
If necessary, modify the content of "P0403 –
„
Motor Rated Frequency".
Press the key  for the next parameter.
„
9
To end the Start-up routine, press the Key
„
BACK/ESC.
To return to the monitoring mode, press the key
„
BACK/ESC again.
- English -