Menu Basic - Basic Application - WEG MW500 User Manual

5.3.3 Menu BASIC – Basic Application
Seq Indication on the Display / Action
1
Monitoring mode. Press the key ENTER/MENU
„
to enter the 1st level of the programming mode.
2
The PARAM group is selected, press the
„
keys  or  until selecting the BASIC group.
3
When the BASIC group is selected press the
„
key ENTER/MENU.
4
Basic Application routine is star ted. If
„
necessary, modify the content of "P0100 –
Acceleration Time".
Press the key  for the next parameter.
„
5
If necessary, modify the content of "P0101 –
„
Deceleration Time".
Press the key  for the next parameter.
„
Figure 5.6: Sequence of the Basic Application group
- English -
Powering up and Start-up
Seq Indication on the Display / Action
6
If necessary, modify the content of "P0133 –
„
Minimum Speed".
Press the key  for the next parameter.
„
7
If necessary, modify the content of "P0134 –
„
Maximum Speed".
Press the key  for the next parameter.
„
8
If necessary, modify the content of "P0135 –
„
Maximum Output Current".
Press the key  for the next parameter.
„
9
To end the Start-up routine, press the key
„
BACK/ESC.
To return to the monitoring mode, press the
„
key BACK/ESC again.
MW500 | 31