WEG MW500 User Manual page 28

Keypad (HMIR) and Basic Programming
Figure 4.3 illustrates the basic browsing of the operating modes of the HMIR.
It is the initial status of the HMIR after the
„
powering up and of the initialization screen,
with default values.
The field Menu is not active in this mode.
„
The main display, secondary display and bar
„
graph indicate the values of three parameters
predefined by P0205, P0206 and P0207.
From the monitoring mode, when you press
„
the key ENTER/MENU, you commute to the
setting mode.
Level 1:
This is the first level of the setting mode. It is
„
possible to choose the parameter group using
the keys  and .
The main display, secondary display, bar
„
graph and measurement units are not shown
in this level.
Press the key ENTER/MENU to go to level 2 of
„
the setting mode – parameter selection.
Press the key BACK/ESC to return to the
„
monitoring mode.
Level 2:
The number of the parameter is shown on the
„
main display and its content on the secondary
display.
Use the keys  and  to find the desired
„
parameter.
Press the key ENTER/MENU to go to level
„
3 of the setting mode – modification of the
parameter content.
Press the key BACK/ESC to return to level 1
„
of the setting mode.
Level 3:
The content of the parameter is shown on the
„
main display and the number of the parameter
is shown on the secondary display.
Use the keys  and  to configure the new
„
value for the selected parameter.
Press the key ENTER/MENU to confirm the
„
modification (save the new value) or BACK/
ESC to cancel the modification (not save the
new value). In both cases, the HMIR returns to
level 2 of the setting mode.
22 | MW500
Monitoring Mode
Setting Mode
Figure 4.3: Operating modes of the HMIR
- English -
Monitoring
BACK ENTER
ESC MENU
Setting
Level 1
BACK ENTER
ESC MENU
Setting
Level 2
BACK ENTER
ESC MENU
Setting
Level 3