Start-Up; Start-Up (Using Superdrive And Default Circuit Configuration); Startup Menu (Using Remote Keypad (Hmir)) - WEG MW500 User Manual

5.3 START-UP

5.3.1 Start-up (using Superdrive and default circuit configuration)

When there is no possible to use the HMIR to start-up the drive, it is possible to use the Superdrive
configuration software for parameters setting and default circuit configuration for start-up, as
shown in Figure 5.3 on page
For default configuration the commands of the inverter are the following:
Speed reference is set via knob reference.

5.3.2 STARTUP Menu (Using Remote Keypad (HMIR))

The start-up is explained in a very simple way, using the programming features with the existing
parameter groups in the menus STARTUP and BASIC.
After the hardware pre-configuration, the inverter will operate with a different control type.
25.
S1 S2 S3
S4
1 3 5 7 9
2 4 6 8 10
Figure 5.3: Default circuit configuration
Table 5.1: Default functions configurations
Function
Run/Stop
FWD/REW
Reset
LOC/REM
Powering up and Start-up
GND
Shield
11 13 15
12 14 16
DIx
DI1 (S1)
DI2 (S2)
DI3 (S3)
DI4 (S4)
MW500 | 25