Start-Up; Start-Up (Using Superdrive And Default Circuit Configuration) - WEG MW500 User Manual

5.3 START-UP

5.3.1 Start-up (using Superdrive and default circuit configuration)

When there is no possible to use the HMIR to start-up the drive, it is possible to use the
Superdrive configuration software for parameters setting and default circuit configuration
for start-up, as shown in
For default configuration the commands of the drive are the following:
Speed reference is set via knob reference.
figure 5.3.
S1 S2 S3 S4
1 3 5 7 9
2 4 6 8 10
Figure 5.3: Default circuit configuration
Table 5.1: Default functions configurations
Function
Run/Stop
FWD/REW
Reset
LOC/REM
- English -
Powering up and Start-up
GND
Shield
11 13 15
12 14 16
DIx
DI1 (S1)
DI2 (S2)
DI3 (S3)
DI4 (S4)
MW500 | 27