Wall Mounting Instructions
Step
1
For wall mounting, use the adaptation plate
accessory.
2
Fix the plate with the motor seal and 10
stainless steel screws in the rear of the drive.
Action
Figure C.2: Wall mounting instructions
Step
3
Use a cable gland to install the input power
supply (X1 terminal block) and output
motor wire (X2 terminal block). If necessary
connect the PTC terminals to XC5 (PTC
connector).
4
Close the drive and don't forget to connect
the ground plug to the front cover.
Appendix C
Action
MW500 | 47