Spi/Bios Updating Procedures - NCR RealPOS 70XRT User Manual

SPI/BIOS Updating Procedures

1. Insert the media containing the SPI/BIOS update software in the 7403.
2. Connect a USB keyboard to the terminal.
3. Apply power to the terminal.
4. The terminal boots and displays the SPI/BIOS Update main menu.
Important: The update procedure requires two boots from the SPI/BIOS media.
Be sure to set your boot order accordingly to make this happen. You can change
the boot order temporarily in the BIOS Setup Boot Menu or you can press [F8]
during boot (when you see the NCR logo) to enter the Boot Select menu.
•
If you are using the integrated CD/DVD Drive select CD/DVD:P1-DV-28S-V.
•
If you are using the external USB CD Drive select USB:TEAC
•
If you are using a USB Memory Drive select USB:xxxx
There are six options from the main menu to run the update program. Three run
automatically and two are interactive. Option 1, the Automatic SPI and BIOS
Update executes automatically in 10 seconds unless the up/down arrow is
pressed.
Automatic Method
With the Automatic Method you may see a prompt to enter the DMI (Desktop
Management Interface), which is the terminal Class/Model/Serial information. This
happens if the program detects invalid DMI information in the current BIOS, or if
you are replacing the processor board, which has no Class/Model/Serial information
in the BIOS.
Important: DMI information is mandatory.
Interactive Method
This method permits you to input/replace the Class/Model/Serial information that is
stored in the BIOS.
Note: DMI information that is currently stored in the BIOS is displayed during
power up. Press [Tab] at the NCR Logo to remove the logo. Press [Pause] to
freeze the screen. Press [Esc] to continue.
Chapter 14: BIOS Updating Procedures 14-3
CD-W552E.
xxx.