Door Hinge Replacement - Electrolux 30” GAS FREESTANDING RANGES Service Update Manual

Disassemble Door
1. Place the door with the handle side down on a
protected work surface. The handle should hang
off the edge of the bench or table.
2. Remove the bottom screws that secure the in-
ner liner to the outer door panel. (Fig. 1)
3. Remove the two handle mounting screws and
remove the door handle. (Fig. 4)
4. Carefully separate the inner door panel and
hinge assembly from the outer panel. Place the
assembly with the hinge side hanging slightly off
the work surface.
5. Remove the two hinge mounting screws and
lower the hinge assembly away from the inner
door panel. (Fig. 3 & Fig. 4).
6. Install new hinge and reverse the steps to reas-
semble the oven door.
TIP: T
O EASE INSTALLATION OF NEW HINGE
THE SELF TAPPING SCREWS INTO THE SCREW HOLES IN THE NEW
. T -
HINGE HIS WILL PRE CUT THREADS INTO THE HINGE AND ALLOW
FOR EASIER STARTING OF THE SCREWS ONCE THE HINGE IS IN POSI
.
TION
When replacing the door hinges you must ensure
that the hinge lock lever is in the fully engaged
position in order to reinstall the oven door on
the range. The hinge is replaced as a complete
assembly only.
The same hinge assembly design is used for
many different oven doors but with different door
spring pull weights. The color of the door spring
determines the pull weight. Make sure that the
replacement hinge spring color is correct for the
model that is being serviced.

Door Hinge Replacement

,
INSTALL AND REMOVE
-
Page 34
FIG. 1
Bottom Screws
FIG. 2
Handle Mounting Screws
Hinge Mounting Screws
FIG. 3
FIG. 4
HINGE LOCK
ENGAGED .
HINGE LOCK
DISENGAGED
P/N 316439221