Removal 55 Front Cover (Pl13.2.98) - Dell 3115cn Service Manual

Removal 55 FRONT COVER (PL13.2.98)

The procedures described below must be performed with the MPF COVER (PL13.2.26)
attached to the FRONT COVER (PL13.2.1).
Steps 1 through 7 are for reference. Before removing this component, check that Steps 1 through 7
have been performed.
1) Open FRONT COVER (PL13.2.1).
2) Remove the FUSER.(Removal 8)
3) Remove the REAR COVER. (Removal 49)
4) Remove the COVER BOTTOM. (Removal 50)
5) Remove the COVER POLE IN R.(Removal 51)
6) Remove the COVER POLE R.(Removal 52)
7) Remove the RIGHT COVER. (Removal 54)
8) Remove the one screw (silver, 6mm) that fixes to the printer the ground wire of the HARNESS
ASSY FRONT COVER (PL13.2.13).
When performing the step below, leave the junction connector on the printer side cable.
9) Disengage the connector (P/J5301) of the HARNESS ASSY A-OP-OPP (PL13.2.24) and the
connector (P/J272) of the HARNESS ASSY FRONT COVER.
10) Release the HARNESS ASSY A-OP-OPP and HARNESS ASSY FRONT COVER from the
DUCT DRV PH (PL8.1.8).
Continues to the next page.
Version 2 2007.03.20
Chapter 3 Removal and Replacement Procedures (RRPs)
9)
10)
3 - 79
8)
Gnb03025KA