Replacement 12 PRINT HEAD (PL13.3.99)
When securing the two positions shown in the figure, make sure that the FRAME ASSY
EARTH is under the PLATE EARTH.
7)
Mate the hole of the FRAME ASSY EARTH with the boss of the printer by inserting the two
hooks on the front side of the FRAME ASSY EARTH into the holes of the printer.
8)
Secure the FRAME ASSY EARTH to the printer using the four screws (silver, 6mm).
9)
Replace the two clamps on the harness of the HARN ASSY FUSER AIO to the FRAME ASSY
EARTH.
10) Secure the harness of the HARN ASSY FUSER AIO with the three clamps on the FRAME
ASSY EARTH.
Go to the next replacement step:
Replacement 60 BOX ASSY FAX AIO (PL13.4.4)
Version 2 2007.03.20
NOTE
8)
8)
10)
9)
9)
Chapter 3 Removal and Replacement Procedures (RRPs)
NOTE
8)
7)
3 - 127
8)
Gnb03152KA