Dell 3115cn Service Manual page 532

Replacement 10 PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE (PL8.1.2)
When performing the step described below, the harness of the connector to be engaged
to the DEVE MOTOR must be routed through the hook above the FEED DRIVE ASSEM-
BLY (PL8.1.7).
3) Replace the clamp and harness together to the PHOTOCONDUCTOR (PC) / DEVELOPER
(DEV) DRIVE.
4) Engage the connector (P/J211) of the MAIN MOTOR, the connector (P/J221) of the SUB
MOTOR, the connector (P/J222) of the DEVE MOTOR, and the connector (P/J2761) of the
EXIT CLUTCH in the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE.
5) Replace the DUCT DRV MAIN by mating its three hooks into the holes on the PHOTOCON-
DUCTOR (PC) / DEVELOPER (DEV) DRIVE, and lock the bosses by sliding the DUCT DRV
MAIN forward.
6) Replace the one remaining screw (silver, tap, 10mm) that fixes the PHOTOCONDUCTOR
(PC) / DEVELOPER (DEV) DRIVE to the printer.
7) Route the harness of the PHOTOCONDUCTOR (PC) / DEVELOPER (DEV) DRIVE to the
DUCT DRV MAIN.
8) Replace the BRACKET FUSER by mating its two holes with the bosses on the printer.
9) Secure the BRACKET FUSER using the two screws (silver, tap, 10mm).
Go to the next replacement step:
Replacement 52 INTERLOCK SWITCH (PL13.5.3)
Version 1 2006.11.28
Chapter 3 Removal and Replacement Procedures (RRPs)
8)
4)
4)
5)
4)
4)
3)
NOTE
3 - 123
9)
9)
7)
6)
Gnb03112KA