Replacement 56 Humidity Sensor (Pl13.5.11) - Dell 3115cn Service Manual

Replacement 55 MACHINE CONTROL UNIT (PL13.5.13)
When the MACHINE CONTROL UNIT is replaced with a new one, perform the following
steps. (After completing all the steps up to Replacement 75.)
5) Plug in the power cord to the outlet, and power on the printer.
6) Perform the diagnostic operation of NVM Load, and write the data into MCU.
7) Turn on the power while pressing the
panel.
8) Enter the password, push the
comes up.
9) Press the
10) Press the
11) Press the
12) Press the
13) After the NVM Load is complete, press the [CANCEL] key several times until
displayed.
14) Press the
15) Press the
Go to the next replacement step:

Replacement 56 HUMIDITY SENSOR (PL13.5.11)

Version 1 2006.11.28
key twice and push the
key several times until
key several times until
key several times until
key twice, and NVM Load is performed.
key several times until
key three times, and
Chapter 3 Removal and Replacement Procedures (RRPs)
key, the key and the [MENU] key on the control
IOT Diag is displayed. Press the
NVM Settings is displayed. Press the
NVM Load is displayed. Press the
Complete is displayed.
Ready to Print is displayed.
3 - 192
key once. The diagnostic screen
key once.
key once.
key once.
IOT Diag is