Replacement 28 Right Arm Assembly (Pl13.3.98) - Dell 3115cn Service Manual

Replacement 28 RIGHT ARM ASSEMBLY (PL13.3.98)

When the RIGHT ARM ASSEMBLY and LEFT ARM ASSEMBLY are removed at the
same time, use caution not to confuse their securing positions.
The HOLDER DAMPER H and DAMPER OIL H for the RIGHT ARM ASSEMBLY are yel-
low, while the HOLDER DAMPER and DAMPER OIL for the LEFT ARM ASSEMBLY are
black.
1) Replace the HOLDER DAMPER H to the printer together with the DAMPER OIL H.
2) Replace the SPRING SUPPORT to the printer.
3) Replace the LINK R by mating the backside groove on the LINK R with the boss on the printer
and then pulling the DAMPER OIL H slightly upward.
When performing the step described below, pay attention to the orientation of the LEVER
RELEASE. Ensure that the longer hollow boss of the LEVER RELEASE faces the
HOLDER DAMPER H.
4) Replace the LEVER RELEASE to the HOLDER DAMPER H.
Continues to the next page.
Version 2 2007.03.20
Chapter 3 Removal and Replacement Procedures (RRPs)
3)-1
2)
1)
(Yellow)
3)-2
3 - 147
4)
NOTE
Gnb03087KB