Dell 3115cn Service Manual page 436

Removal 16 INTEGRATED FEEDER ASSEMBLY (PL3.2.99)
Steps 1 through 8 are for reference. Before removing this component, check that Steps 1 through 8
have been performed.
1) Open FRONT COVER (PL13.2.1).
2) Remove the FUSER.(Removal 8)
3) Remove the REAR COVER. (Removal 49)
4) Remove the COVER BOTTOM. (Removal 50)
5) Remove the COVER POLE IN R.(Removal 51)
6) Remove the COVER POLE R.(Removal 52)
7) Remove the RIGHT COVER. (Removal 54)
8) Remove the FEED DRIVE ASSEMBLY. (Removal 15)
9) Remove the e-rings that fix the BEARINGs on the left and right sides of the ROLL ASSY MSI
(PL3.1.8), and then remove the BEARINGs to the inside.
When performing the step described below, take care not to drop and lose the BEARING
EARTH (PL3.1.6) and the BEARING (PL3.1.13).
10) Remove the ROLL ASSY MSI by sliding it to the right and pulling out its left side shaft from
the left side hole on the printer and then pulling it out to the lower left.
Continues to the next page.
Version 2 2007.03.20
9)-1
9)-2
10)
Chapter 3 Removal and Replacement Procedures (RRPs)
9)-2
3 - 27
9)-1
Gnb03021KA