Print Cartridge Service - Xerox WORKCENTRE PE 220 Service Manual

Introduction
8. Maintain continuous electrical contact between the ESD and the assembly into which it will be
installed, until completely plugged or soldered into the circuit.
9. Minimize bodily motions when handling unpackaged replacement ESDs. Normal motions, such
as the brushing together of clothing fabric and lifting one's foot from a carpeted floor, can generate
static electricity sufficient to damage an ESD.
Super Capacitor or Lithium Battery Precautions
1. Exercise caution when replacing a super capacitor or Lithium battery. There could be a dan-
ger of explosion and subsequent operator injury and/or equipment damage if incorrectly
installed.
2. Be sure to replace the battery with the same or equivalent type recommended by the manu-
facturer.
3. Super capacitor or Lithium batteries contain toxic substances and should not be opened,
crushed, or burned for disposal.
4. Dispose of used batteries according to the manufacturers instructions.

Print Cartridge Service

Only print cartridges supplied by Xerox should be used. Printing defects or set damage caused by
the use of non-approved print cartridges or un-licensed toner refills are not covered by the guar-
antee.
Precautions on Safe-keeping of Print Cartridge
Excessive exposure to direct light for more than a few minutes may cause damage to the car-
tridge.
Service for the Life of Print Cartridge
If the printed image is light due to the toner supply becoming low you can temporarily improve the
print quality by redistributing the toner (Shake the print cartridge), however you should replace the
print cartridge to solve the problem permanently.
Redistributing Toner
When the print cartridge is near the end of its life, white streaks or light print occurs. The LCD dis-
plays the warning message, "Toner Low." You can temporarily re-establish the print quality by re-
distributing the remaining toner in the cartridge.
Standard of guarantee for consumable parts.
Please refer to User Manual or Instructions on Fax/Printer Consumables SVC manual for the cri-
teria for judging the quality of consumable parts the standard of guarantee on those parts.
• Spotting a refilled cartridge by eye.
One way security screws are used in the manufacture of the cartridge – check if these are dam-
aged.
viii 11/05 Workcentre PE 220