Gp 6 Lcd Status Error Messages - Xerox WORKCENTRE PE 220 Service Manual

GP 6 LCD Status Error Messages

STATUS
Document Jam
Door Open or Jam
Cover Open
NO paper
PAPER JAM 0
PAPER JAM 1
PAPER JAM 2
Communication Error
Line Error
NO ANSWER
INCOMPATIBLE
LINE BUSY
POWER FAILURE
STOP PRESSED
MEMORY FULL
FUSER ERROR
LSU ERROR
LSU ERROR
TONER LOW
TONER EMPTY
BYPASS JAM
GROUP is not available
RETRY REDIAL?
NO. NOT ASSIGNED
Workcentre PE 220
LCD Display
Document Jam
[Front or Rear]
[Cover Open]
[No Paper]
Add Paper
[Paper Jam 0]
Open/Close Door
[Paper Jam 1]
Open/Close Door
[Paper Jam 2]
Check Inside
[COMM. Error]
[Line Error]
[No Answer]
[Incompatible]
Line Busy
Power Failure
[Stop Pressed]
Memory Full
CRU Fuse Error
[Hsync Error]
[LSU Error]
[Toner Low]
[Toner Empty]
[Bypass Jam]
Group Not Available
Retry Redial?
NO. Not Assigned
Table 1:
When Document Jam occurred at ADF module.
When machine' front side cover or Jam Cover was
opened.
When there is no paper in CASSETTE Tray.
When the machine encountered paper jam in pick up
area, Machine displays on the LCD until DOOR OPEN &
CLOSE.
When the machine encountered paper jam in paper exit
of Machine, machine displays on the LCD until DOOR
OPEN & CLOSE.
When the machine encountered paper jam in paper exit
of Machine, machine displays on the LCD until DOOR
OPEN & CLOSE.
When the machine has a problem in communication.
Machine displays this in case of Transmission.
Machine displays this in case of fax handshaking step of
Reception.
When the machine has problem in case of Fax Data
reception step.
When the machine could not connect to remote fax after
Completion of redial up to redial counter in system data.
Remote party did not have the requested feature, such
as polling.
The remote fax did not answer.
When the machine user memory has not been backed
up and there was power off / on.
When the operator pressed the STOP key during trans-
mission.
When the machine has encountered the user memory
was full,
When the machine failed in installing the new print car-
tridge.
Tech mode
User mode
The LSU does not reach the READY state,
The machine has encountered the Toner Low,
The machine has encountered the Toner Empty,
The machine detected the non feeding from BYPASS
Tray.
You have tried to select a group location where only a
single Location number can be used.
The machine is waiting for the programmed interval to
automatically redial a previously busy station.
The speed dial location you tried to use has no number
assigned to it.
11/05
General Procedures and Information
Descriptions
6-41