Form Feed; Banner Page; Printing After Resetting The Printer - Ricoh Aficio SP 5200DN Operation And Use Manual

1. In the [Printers] or [Printers and Faxes] window, open the printer properties.
2. Click the [PostScript] tab.
When using Windows XP, and Windows Server 2003/2003 R2, click the [Device Settings] tab, and
then proceed to step to clear the check box.
3. Click [Advanced].
4. Clear the [Send CTRL+D before job] and [Send CTRL+D after job] check boxes, and then click
[OK].
5. Click [OK] to close the printer properties window.

Form Feed

Do not use NetWare to configure form feed. Form feed is controlled by the printer driver on Windows. If
NetWare form feed is configured, the printer may not print properly.
Follow the procedure below to disable form feed according to the operating system used:
• Clear the [Form feed] check box on the [NetWare Settings] tab in the printer properties window.

Banner Page

Do not use NetWare to configure a banner page.
Follow the procedure below to disable banner pages according to the operating system used:
• Clear the [Enable banner] check box on the [NetWare Settings] tab in the printer properties dialog
box.

Printing after Resetting the Printer

Printer to print server connection requires 30 - 40 seconds to resume after the printer is reset. During this
period, jobs may be accepted (depending on NetWare specifications) but not printed.
To print after resetting the printer as the remote printer, check on the print server that the remote printer is
disconnected, or wait for two minutes before trying to print.
Using as the NetWare Print Server/Remote Printer
2
33