Setting Up The Printer - Ricoh Aficio SP 5200DN Operation And Use Manual

1. Getting Started

Setting Up the Printer

This section explains how to enable encryption of transmitted data and configure the administrator account.
1
If you want higher security, make the following setting before using the printer:
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Network], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Machine IPv4 Address], and then press the [OK] key.
5. Specify IPv4 Address.
6. Be sure to connect the printer to a network that only administrators can access.
7. Start the Web Image Monitor, and then log in to the printer as the administrator.
For details about logging in to Web Image Monitor as an administrator, see p.22 "Using Web
Image Monitor to Configure Administrator Authentication".
8. Install the server certificate.
For details, see p.94 "Protection Using Encryption".
9. Enable secure sockets layer (SSL).
10. Enter the administrator's user name and password.
Firmware Update Cautions
If "IPsec" is enabled, all information on the network will be encrypted. This allows you to perform
firmware updates securely.
If "IPsec" is not enabled, the information on the network may not be encrypted depending on the
protocol. If you want to perform a firmware update when "IPsec" is not enabled, be sure to do so only
if your network environment is protected against electronic eavesdropping and similar security threats.
• For details on how to specify the IPv4 address, see "Ethernet Configuration", Hardware Guide.
12