Ricoh Aficio SP 5200DN Operation And Use Manual page 196

9. Troubleshooting
Failed to connect to server for Remote Diagnostics.
The printer cannot communicate with Remote Communication Gate. Check the connection to the Remote
Server Gate.
Independent-supply toner
Independent-supply toner is set. Use toner recommended for this printer.
IPDS font error. Turn power switch off then on. Select Reset IPDS Fonts in Maintenance.
IPDS font error has occurred. Perform the shutdown procedure, and then turn off the power of the machine.
Turn on the power again, and then execute [Reset IPDS Fonts].
IPv6 Address already exists Link-local Address(109/209)
The same IPv6 address already exists. Consult your network administrator.
IPv6 Address already exists Stateless Address(109/209)
The same IPv6 address already exists. Consult your network administrator.
IPv6 Address already exists Manual Config. Address(109/209)
The same IPv6 address already exists. Consult your network administrator.
Load paper in (tray name) or [Cancel] to FormFeed.
There is no paper in the specified tray. Load the specified paper in the tray, press [JobReset] to reset the
job.
Option RAM Error
The printer cannot detect an optional SDRAM module. It may be incorrectly installed.
Check if it is installed properly.
9
For details about installing the unit, see p.52 "Installing the Memory Expansion Units".
Output tray is full.
The output trays are full. Remove the paper.
Parallel I/F Error
The printer's self diagnostic test failed due to a loopback error. Replace the IEEE 1284 board that caused
the error. For details, see p.59 "Installing the Interface Units".
Prepare Replacement Check print cartridge replacement(s).
The toner has run out, or the photo conductor unit has reached the end of its service life. Prepare a new
print cartridge.
Printer Font Error.
There are problems with the printer's font file.
Contact your sales or service representative.
174