Checking The Coolant Level; Changing The Coolant - Yamaha YFM7FGPW Service Manual

CHECKING THE COOLANT LEVEL/

CHANGING THE COOLANT

1
a
EBS00076
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
NOTE:
The coolant level must be checked on a cold
engine since the level varies with engine tem-
perature.
2. Check:
• coolant level
The coolant level should be between the
minimum level mark a and maximum level
mark b in the coolant reservoir.
CAUTION:
_
• Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant, check
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However, soft
water may be used if distilled water is not
available.
3. If the coolant is at or below the minimum
level mark, remove the left side panel.
Refer to "SEAT AND SIDE PANELS".
4. Remove the reservoir cap 1, add coolant
or distilled water to the maximum level mark
a, install the reservoir cap, and then install
the panel.
Coolant reservoir capacity (up to
the maximum level mark):
0.17 L (0.15 Imp qt, 0.18 US qt)
EBS00075
CHANGING THE COOLANT
1. Remove:
• right side panel
• left side panel
Refer to "SEAT AND SIDE PANELS".
• front carrier
• upper panel
Refer to "FRONT CARRIER AND FRONT
GUARD".
3 - 35
CHK
ADJ