Removing The Ac Magneto Rotor - Yamaha YFM7FGPW Service Manual

3
2
1
1
2
AC MAGNETO
EBS00259

REMOVING THE AC MAGNETO ROTOR

1. Remove:
• lead holder 1
• AC magneto cover
NOTE:
_
1
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
2. Remove:
• AC magneto rotor nut 1
• washer
NOTE:
_
• While holding the AC magneto rotor 2 with
the sheave holder 3, loosen the AC mag-
neto rotor nut.
• Do not allow the sheave holder to touch the
projection on the rotor.
Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
3. Remove:
• AC magneto rotor 1
(with the starter clutch)
• woodruff key
CAUTION:
To protect the end of the crankshaft, place
an appropriate sized socket between the
flywheel puller set center bolt and the
crankshaft.
NOTE:
• Use the flywheel puller 2.
• Install the flywheel puller bolts to the
threaded holes of the starter clutch.
• Make sure the flywheel puller is centered
over the AC magneto rotor.
4 - 45
ENG