Yamaha YFM7FGPW Service Manual page 454

EBS00812
7. Coolant temperature sensor
• Remove the coolant temperature sensor
from the cylinder head.
• Connect the pocket tester (Ω × 100) to the
coolant temperature sensor 1 as shown.
• Immerse the coolant temperature sensor
in a container filled with coolant 2.
NOTE:
_
Make sure the coolant temperature sensor
terminals do not get wet.
• Place a thermometer 3 in the coolant.
• Slowly heat the coolant, and then let it cool
to the specified temperature indicated in
the table.
• Measure the coolant temperature sensor
resistance.
Coolant temperature sensor
resistance
290 ~ 354 Ω at 80 °C (176 °F)
WARNING
_
• Handle the coolant temperature sensor
with special care.
• Never subject the coolant temperature
sensor to strong shocks. If the coolant
temperature sensor is dropped, replace
it.
Coolant temperature sensor
18 Nm (1.8 m · kg, 13 ft · lb)
COOLING SYSTEM
• Does the coolant temperature sensor
operate properly?
YES
EBS01090
8. Wiring
• Check the entire cooling system's wiring.
Refer to "CIRCUIT DIAGRAM".
• Is the cooling system's wiring properly
connected and without defects?
YES
Replace the ECU.
9 - 49
– +
ELEC
NO
Replace the coolant
temperature sensor.
NO
Properly connect or
repair the cooling
system's wiring.