Regal 42SC Owner's Manual page 190

LIGHTING-GENERAL
Your vessel features various styles of lighting such as
overhead, hanging locker, reading and fl orescent types.
Each lighting fi xture requires specifi c bulb types and re-
placement procedures. Read and understand the following
warning.
WARNING
!
AVOID SERIOUS INJURY!
EARLIER HALOGEN & XENON LIGHT BULBS
DEVELOP EXTREMELY HOT
TEMPERATURES.
NEVER REMOVE A HOT LIGHT BULB SINCE
IT COULD CAUSE SKIN BURNS.
WAIT FOR THE BULB TO COOL
BEFORE ATTEMPTING TO REMOVE IT.
Note: The bulbs listed in the following pages can be
ordered through a Regal dealer or may be available at
speciality lighting or box stores. When changing the ear-
lier halogen light bulbs never touch the bulb surface with
your fi ngers as premature burn out can occur due to oil
on the skin touching the bulb surface. Handle bulbs only
from the ends.
To change the earlier halogen overhead light bulb follow
these steps:
Using a sharp object such as a small slotted screwdriver,
slide it between the lens cover and the light base.
Pull down on the lens cover to access the bulb.
Remove the defective bulb.
Replace the bulb with a 12 volt, #10WXM halogen type.
Line up the space in the lens cover/body with the notched
area of the light base.
Push the prongs on the lens cover/body upward until they
seat into the light base.
Later overhead lights use LED technology which is known
for clear visibility, long service life, and energy savings.
Note: These later LED lights will feel much cooler than the previ-
ous halogen type.
Insert Here To
Loosen Cover
6
Chapter 7