Regal 42SC Owner's Manual page 92

50 AMP 50 AMP
DOCKSIDE DOCKSIDE
CORD CORD
INLET INLET
TYPICAL BOAT TRANSOM TYPICAL BOAT TRANSOM
The illustration above shows a typical transom layout
with the optional cord reel system. Notice the cord reel
switch for cord retrieval. Once the cord is inside the inlet
be sure to close the cover to reduce the effects of any
water intrusion.
POSSIBLE PROBLEMS/SOLUTIONS
1. After the dockside cord is hooked up to
the yacht and the marina dock power cen-
ter and the AC ship's panel main breaker
for shorepower 1 or 2 is activated no volt-
age is shown on the main panel AC volt
meter.
Check the breaker on the marina dock power center to
ensure it is activated.
On earlier yachts check the triple pole single throw break-
er located near the battery charger in the bilge.
On later yachts check the ELCI 3 pole single throw
breaker/voltage sensing device. The "power" icon should
show green. If a leakage fault exists a "red" icon will light
indicating the breaker is "tripped". Use the test button to
reset the breaker.
2. The marina dock power center lacks a 50 amp plug.
Call the dockmaster or marina personnel. An adapter cord
may be available. NEVER IMPROVISE ANY TYPE OF
CORD OR POWER INLET CHANGES!
Also, an adapter cord may be purchased that delivers twin
CORD REEL CORD REEL
30 amp service and adapts to the 50 amp yacht dockside
SWITCH SWITCH
cord. Adapters can be found at retail boating outlets.
3. The cord reel switch fails to retrieve the dockside
cord.
Check the cord reel breaker located on the battery man-
agement panel.
39
Systems