User Manual; Alarm System Control Devices; Electronic Key; System Operation - Basic Configuration - Gemini 953 Installation And Use Manual

USER MANUAL

3.0 - ALARM SYSTEM CONTROL DEVICES

The remote controls and electronic key are used to operate the alarm system.
A PIN Code can also be used to emergency override the system should the
remote control be lost or inoperative. Override PIN Code is entered by means
of the ignition key (see chapters 8 and 9).
3.1 - REMOTE CONTROL
The remote control has 2 different function buttons.
The textured button is for arming/disarming the alarm while the smooth button
is used to exclude or trigger the siren.
The remote control has a low charge battery indicator that gives early warning
to avoid malfunctioning. When the batteries are fully charged, the LED shows
a steady light at the press of a button. If the batteries are low, the LED will start
blinking when the button is pressed. Replace the batteries, weak batteries will
prevent the remote control from properly operating the alarm system.
!
Button 1 : Alarm system arming/disarming
!
Anti-hijack feature activation
!
Hazard flashers activation
!
Button 2: Panic siren activation/deactivation
!
Siren silencing during alarm conditions
!
Siren exclusion when arming
!
Shock sensor adjustment

3.2 - ELECTRONIC KEY

The electronic key is a simplified remote control. In emergency situations (ex.
in case of remote control failure), it can be used to arm/disarm the alarm or
activate/deactivate the anti-hijack feature (if enabled).
To use the electronic key, simply touch it to its receptacle.
The touch receptacle incorporates a LED warning light that serves as both a
system status indicator and a visual theft deterrent.
Page 3
To arm the alarm system, press remote control button 1 or insert the electronic
key into its receptacle . Arming is confirmed by a flash of the turn indicators and
2 short beeps. The LED turns ON steady.
LED
indicator
If, during the arming process, the topcase or seat are open or incorrectly closed, a
Button 1
low-tone signal (boop) will sound after the arming confirmation tones.
The alarm will arm but an alarm condition will be triggered after the arming delay.
Button 2
After the arming confirmation signals, the LED turns ON steady to indicate the arming
delay; the system will become fully armed after 20".
Engine immobilization and optional module outputs are active during the arming delay.
During the first 4" of the arming delay, the alarm siren can be excluded by
pressing remote control button 2. Siren exclusion is confirmed by a short flash
of the turn indicators.
NB:
Electronic Key Receptacle Positioning
Electronic key
4.0 - SYSTEM OPERATION - BASIC CONFIGURATION

4.1 - ARMING

4.2 -

TOPCASE/SEAT OPEN WARNING

4.3 - ARMING DELAY

4.4 - SIREN EXCLUSION

Siren exclusion is bound to a single arming cycle.
CAUTION
If the siren is excluded (MUTE alarm) only the turn indicators will flash
during an alarm event. Engine immobilization will remain enabled.
Electronic key
Page 4