Telephone Number 1 Programming - Gemini GEM-P801 Installation Instructions Manual

WI1089 GEM-P801 Installation Instructions
Receiver Formats: Ademco Slow, Radionics
Fast, Silent Knight Fast and Universal High
Speed. This is a sophisticated data format
used to enhance the speed and check the
accuracy of the received transmission. This
format should be used whenever the central
station has this capability. Instead of sending
a second round to verify correct data, the
panel sends a Sumcheck digit after sending
the Subscriber ID and Alarm Code.
(3) Single Digit - 3/1 Format.
Subscriber ID number and a 1-digit Alarm
Code will be transmitted.
(4) No Handshake - (All receiver formats
except Pager Format)
If programmed no Handshake/Kissoff is
required by the panel.
[34]Zone Report, Telco 1
Select zone(s) required to send an alarm
report to Telephone Number 1.
[35]Zone Restore Report, Telco 1
Select zone(s) required to send a restore
report to Telephone Number 1. The zones
will send a restore after Bell time-out, unless
programmed as silent zones.
[36]System Reporting, Telco 1
(1) Keypad Fire - Program to activate a
Keypad Fire report (
7G
(2) AUX/AMBUSH - Program to activate an
16
AUX or AMBUSH report (
(3) Panic - Program to activate a Panic
report (
9G
(4) Test Timer - Program to activate a Test
Timer report.
[37]System Reporting, Telco 1
(1) AC Fail Report - Program to activate an
AC Fail report (15 minute fixed report
delay).
3-digit
(2) Low Battery Report - Program to
activate a Low Battery report.
(3) *Trouble Report - Program to activate a
Trouble report.
(4) Fire Report - Program to activate a Fire
report.
*Includes Bell Cut, Fire Trouble, Receiver
Fail-to-Respond,
Receiver JAM, Wireless Smoke Low
Battery, Wireless Smoke Supervisory Fail.
Point ID format will report trouble(s) by
device and ID number.
[38]System Restore Report, Telco 1
(1) AC Restore - Program to activate an AC
Restore report.
(2) Battery Restore - Program to activate a
Battery Restore report.
(3) Trouble Restore - Program to activate
).
a Trouble Restore report.
(4) Fire Restore - Program to activate a
).
8G
[39]Opening/Closing Report, Telco 1
).
Backup Telephone Programming
[40]Subscriber ID Number (Telco 2)
[41]Telephone Number 2
Receiver Tamper,
[42]Receiver Format (Telco 2)
[43]Receiver Options (Telco 2)
Fire Restore report.
Select users required to send opening and
closing reports to Telephone Number 1. Do
not program for users that are intended to
send an Opening After Alarm
Code) or Conditional Closing reports.
For 4/2 format enter a 4 digit number. If 3/1
format is required enter a 3 digit number then
press the key.
F
Program the phone number to be dialed for
Telephone Number 2. A fixed dial tone
detection (E) is included prior to the Dialing
Prefix [44]. Dial tone detection can be
disabled by programming No Dial Tone
Detection [46-1]. To program any additional
delay enter a "D" where required in the phone
number.
Select the format that will be used to report
for Telco 2 (Backup reporting).
section [32].
Refer to section [33] Receiver Options.
(Cancel
Refer to