Table of Contents
Advertisement
6.0 - TURN INDICATORS WIRING DIAGRAMS
LEFT TURN
INDICATORS
ORANGE
GEMINI
ORANGE
931T-IT
WHITE-ORANGE
SYSTEM
WHITE-ORANGE wire must ONLY be
connected if the system is to operate via
the turn indicators.
6.2
- CONNECTIONS FOR VEHICLES WITH SEPARATE LINES
WHITE-ORANGE wire must ONLY be
connected if the system is to operate via
the turn indicators.
WHITE-ORANGE
ORANGE
GEMINI
931T-IT
SYSTEM
ORANGE
Insert six
2-Amp diodes
6.3 - CONNECTION TO HAZARD SWITCH
GEMINI
931T-IT
SYSTEM
PAGE 08 - INSTALLER MANUAL
6.1
- STANDARD CONNECTIONS
RIGHT TURN
INDICATORS
TURN INDICATORS
CONTROL UNIT
Front Side Rear Rear Side Front
LH
LH
LH
RH
RH
If WHITE-ORANGE wire is
connected do not make this
connection.
BLUE
VEHICLE
CIRCUIT
7.0 - CENTRAL LOCKING CONNECTIONS TO ARM/DISARM THE SYSTEM
The alarm system can operate in various modes according to the vehicle on which it is installed and
the available connections (refer to the vehicle installation specifications).
It can be managed via the vehicle CAN BUS line and operate in combination with the turn indicator
flashes and/or the door locking motors. The system automatically manages the different
arming/disarming signals.
The various arming modes are listed below and the connections detailed in the following paragraphs
(refer to the vehicle specific installation instructions available in the restricted area of our website:
www.gemini-alarm.com).
• Arming via CAN BUS line.
• Arming via door lock motors.
• Arming via turn indicator flashes.
• Arming via turn indicator flashes and door lock motors.
• Arming via turn indicator flashes, door lock motors and CAN BUS line.
System arming/disarming and alarms are managed via CAN therefore only connect the alarm CAN
wires to the vehicle CAN line.
System arming/disarming connections must be made to the door lock motors (polarity reversal).
!
If the turn indicators lock/unlock flashes are identical, also connect the door lock motors.
If the turn indicators flash when unlocking with the vehicle mechanical key, this type of
!
RH
To arm/disarm the system, connect the WHITE-ORANGE wire to one of the turn indicators wires and
learn the lock/unlock flashes (par. 9.0).
This type of connection allows the system to operate via the CAN line in combination with the turn
indicators or the door lock motors or both.
The system will automatically manage the different lock/unlock signals according to the selected
configuration and connections.
7.1
- CONNECTIONS AND OPERATION VIA CAN BUS LINE
7.2
- CONNECTIONS TO DOOR LOCK MOTORS
7.3
- CONNECTIONS TO TURN INDICATORS
connection is not recommended.
7.4
- COMBINATION CONNECTION
INSTALLER MANUAL - PAGE 09
Advertisement
Table of Contents
