Installation - Raritan TeleReach TR361 User Manual

Installation

2. INSTALLATION
Steps 1 through 5 below are required for physical installation of TeleReach, and are outlined in this
section.
1. Connect TeleReach to user port(s) of base Raritan KVM Switch in pre-established KVM
configuration
2. Connect TeleReach Admin Console
3. Install User Console(s) for direct analog access to KVM switch
4. Connect power cord to back of TeleReach and AC power source
5. Connect TeleReach to network and/or analog telephone line
6. Proceed to 3. Setup and follow the steps for TeleReach Power Up & Network or Dial-up
Installation and Fine-Tune KVM Configuration From Direct Analog User Console.
Target Computers
KVM
switch
TeleReach
User Consoles
For direct analog access
To KVM switch
TeleReach Admin Console
Target Server(s)
User Console for direct
analog access to KVM
switch
Remote PC
TeleReach
Admin
Console
.................
Figure 2. TeleReach Configuration
Keyboard/monitor for TeleReach administration and setup. From this console only TeleReach
admin screens can be accessed – Target Servers of the connected KVM configuration cannot
be viewed. Required for initial setup of TeleReach.
The servers accessed remotely through TeleReach and its connected KVM configuration.
User Console (keyboard/monitor/mouse) connected through TeleReach for direct analog KVM
switch local access to Target Servers.
A remote Windows-based computer that uses TeleReach Control (TRC) software or Microsoft
Internet Explorer to view Target Servers remotely through TeleReach.
Access via
LAN/WAN, Internet,
or Dial-up Modem
3
Remote PC