Table of Contents
Advertisement
38
7. FINE-TUNE TELEREACH CONTROL SOFTWARE
Run Automatic Color Calibration
Automatic Color Calibration adjusts the Color Settings on TeleReach to reduce excess color noise
and data during digitization of video images. This data streamlining will increase the operational
performance of TeleReach.
Color Calibration should be run when viewing a Windows-based Target Server from a Remote PC
through TeleReach. The Target Server chosen should be of a resolution that appears most often in
your configuration of Target Servers, and one that most closely matches either a 800 x 600 or a 1024
x768 resolution. Since TeleReach Color Settings remain static, and do not change when switching
from one Target Computer to another, running this Color Calibration routine once on a
representational Target Server will benefit all connected Target Servers.
This routine replaces the manual adjustment of the Color Settings on the Video Settings tab in the
Video Settings window (Figure 42). For more information on manual adjustment, or if all connected
Target Computers are of a non Windows-based Operating System, see Important Video Buttons
(Video Settings) in 6. Remote Operation.
NOTE: Automatic Color Calibration should be performed after you have familiarized yourself with
TeleReach remote operations in 6. Remote Operation. Color files needed for the Target Server
reside on the TeleReach Control CD-ROM. Be sure you have previously loaded the TeleReach
Control software on the intended Remote PC, so that you can leave the TeleReach Control CD-ROM
in the CD drive of the selected Target Server prior to departing for the location of your Remote PC.
(Or you may copy the desired test file from the CD-ROM onto the Target Server).
Color Calibration Steps:
In The Server Room:
1. Choose a representational Windows-based Target Server. It should be the server that meets the
following consecutive requirements:
a) Represents the resolution - 800 x 600 or 1024 x 768 – that is the most common among all
Target Servers in the KVM configuration.
b) Has the greatest color depth.
c) For Paragon configurations, represents an average Cat 5 cable length.
2. Insert the TeleReach Control CD-ROM into the CD drive of the chosen Target Server.
3. Access this server locally.
4. Exit the setup program, which is Auto played, by clicking <Cancel> at the InstallShield
Wizard window, and then clicking <Yes> at the Exit Setup window.
5. Leave the TeleReach Control CD-ROM in the CD drive and proceed to your Remote PC.
At The Remote PC:
1. Connect to TeleReach from the Remote PC.
2. Switch to the selected representational Target Server that contains the TeleReach Control
CD-ROM in its CD drive.
3. Set the background of the chosen Target Server to the color test pattern with the appropriate
resolution.
a) On the Target Server double-click My Computer > Control Panel > Display.
Fine-Tune TeleReach Control Software
Advertisement
Table of Contents
