World Mode Regulatory Domain; Radio And Channel Selection - ASCOM i62 Configuration Manual

Configuration Manual
Ascom i62 VoWiFi Handset
6.3.3

World Mode Regulatory Domain

There is a set of regional rules for the world mode settings and the a-band that the VoWiFi
Handset complies to. The preferred and the default setting is "World mode (802.11d)". The
VoWiFi Handset gets its regulatory settings from the AP. If this is not supported by the AP,
then this has to be set in the VoWiFi Handset as follows:
1 Select Network > Network A (B, C, or D).
2 In the World mode regulatory domain drop-down list, select one of the following:
• World mode (802.11d) (default)
• ETSI
• Japan
• USA
6.3.4

Radio and Channel Selection

The VoWiFi Handset supports the 802.11a/n radio and 802.11b/g/n radio, but it cannot
use the 802.11a/n radio and the 802.11b/g/n radio simultaneously. The radio determines
which channels that can be used.
802.11 a/n Channels
Defines which 802.11a/n channels to use. It is recommended to use the value "UNII-1".
Select "Advanced" only if the channels shall be set in the Advanced: 802.11 channels
parameter, see
1 Select Network > Network A (B, C, or D).
2 In the 802.11 protocol drop-down list, select "802.11a/n".
3 In the 802.11a/n channels drop-down list, select one of the following:
Note: The selected World Mode Regulatory Domain determines which channels to be
used. See
• All
• Non DFS
• UNII-1
• UNII-3
• UNII-1, UNII-2
• UNII-1, UNII-2, UNII-3
• UNII-1, UNII-2, UNII-2 Extended
• Advanced
9 December 2011/ Ver. D
Advanced: 802.11 Channels
Bands and Channels used by WiFi
on page 31.
a-radio.
TD 92675EN
30