Configure Handset For Cisco/Ekahau Rtls Solution - ASCOM i62 Configuration Manual

Configuration Manual
Ascom i62 VoWiFi Handset
gives a more accurate location using a third-party Real-Time Location System (RTLS)
solution.
The following RTLS solutions are supported:
• Cisco RTLS Solution
In order to use the Cisco RTLS solution, a Cisco Mobility Services Engine must be used and
configurations in the VoWiFi Handset are required.
• Ekahau RTLS Solution
In order to use the Ekahau RTLS solution, the VoWiFi Handset must have the Ekahau
license (see
configured.
Additionally information about AP location and RTLS location, see Function Description,
Location in Ascom VoWiFi System, TD 92607GB.

6.15.1 Configure Handset for Cisco/Ekahau RTLS Solution

1 Select Location > Common.
2 In the Location scanning drop-down list, select "Enable".
3 In the Scanning interval
4 In the Scans per scanning period
be performed during each scanning period.
If the Ekahau RTLS solution is used, also perform the steps 5 - 8.
5 Select Location > Ekahau.
6 In the EKAHAU license drop-down list, select "Yes". Additional parameters are shown.
7 In the IP address field, enter the IP address to the Ekahau location appliance.
8 In the Listening port field, enter the port the location appliance is listening to.
1. Note that close scanning periods, and frequently scans per period, will shorten the battery time.
9 December 2011/ Ver. D
5.1.7 Upgrade Handset Functionality using License
1
field, set the time between the scanning periods.
1
drop-down list, select how many scans that should
TD 92675EN
on page 17) and also be
55