Platen And Assist Roller - Datamax M-Class Mark II Maintenance Manual

Installation:
1. Place the Isolator against the Centerplate opening as shown and secure it using the two
Screws.
2. Install the Drive Motor; see Section 4.7.

4.8 Platen and Assist Roller

Removal:
1 Turn OFF and unplug the printer.
2. Remove the Fascia and Tearplate (or any other attached output device) and then raise
the Printhead Assembly.
Thumbscrew
3. Remove the Screw that secures the Inner Bearing Plate, and then remove the Inner
Bearing Plate from the Platen Block.
Removal and Replacement
Printhead
Assembly
Tearplate
Fascia
4-20