Front Cover - Datamax M-Class Mark II Maintenance Manual

Removal and Replacement
Installation:
Lower the Side Cover Assembly onto the printer. Install the three removed Screws into the
rear and base of the printer, and tighten the two Screws on the Centerplate.

4.2 Front Cover

Removal:
1. Turn OFF and unplug the printer.
2. Remove the Side Cover Assembly; see Section 4.1.
3. Push up on the Tab (shown) and gently pull the Front Cover forward, off the printer.
Tab
Front
Cover
Installation:
1. Align the tabs on the Front Cover to the slots in the chassis and then push until the
cover snaps into place.
2. Install the Side Cover Assembly; see Section 4.1.
4-3