Basic Connection - Ganz ZR-DHC830NP Instruction Manual

1.3 Basic connection

1.3 Basic connection
The devices and cables should be connected to the back panel as shown above.
Connecting the power cable to the power supply.
1
[Warning]
• The power cable should be plugged in after all devices are connected. The system will
automatically boot once the power cable is plugged in. The front on/off switch is used
when you reboot the system manually.
2 Connect the mouse to the upper PS/2 terminal .
Connect the keyboard to the lower PS/2 terminal.
3
Connect the VGA monitor to the VGA input on the VGA card.
4
Connect the camera signal to the BNC terminals (coaxial type).
5
Connect the Printer to the LPT1 terminal.
6
15
15