Ganz ZR-DHC830NP Instruction Manual page 44

5. Input the PTZ model (protocol), speed (baud rate), address and port settings.
6. Click on the "OK" button once setup is complete.
1
3
4
5
6
7
8
9
Model : Select the PTZ protocol of the installed PTZ.
1
Add : Click on the "Add" button to install the new PTZ protocol.
2
Speed : Select the PTZ speed(2400~115200 Bps).
3
Address : Enter the PTZ address(0~255).
4
Port : Select the port number connected to the PTZ.
5
Mode : Select the port mode connected to the PTZ.
6
Parity : Set bit (None, Odd,Even, Space) to prevent fatal error.
7
Data Bit : Set data bit 4, 5, 6, 7 or 8.
8
Stop Bit : Set stop bit 1, 1.5 or 2.
9
Default : Install the port number with the initial number.
10
2
10
44
44