Table of Contents
Advertisement
5
6
7
Zone : Set the time period for which each area setup will be used. In the zone setting select the
schedule mode and then select the area to set over the 24hr time line period.
Block Count : Configure the number of blocks within the motion grid.
Sensitivity : Set the sensitivity of the motion detection.
Set All Area : Select all the motion detection blocks on the grid.
Erase all area : Clear all the motion detection blocks from the grid.
[Note]
☞
☞
• The motion setting options, schedule mode, area and zone only function when
the detection mode is set to motion detection and are not available for object
watch detection.
Rec Time : Input the pre and the post recording time when the event occurs.
5
Pre rec time : Set the pre-recording time for the period between when the motion was detected and
the time when the DVR starts recording.
Post rec time : Set the post-recording time for the period after when the motion has stopped and
when the DVR stops recording.
6
Action setting : Set the internal buzzer to activate upon motion and select the camera to full screen in
live view upon motion.
Linked PTZ : Set a PTZ camera to move to a preset position upon motion activation.
7
Apply to : The selected channel setting value can be applied to all or just selected channels.
8
8
9
10
58
58
Advertisement
Table of Contents
