Ganz ZR-DHC830NP Instruction Manual page 37

6 Preset/Pattern/Run Tour/Aux : Sets the PTZ position to a ID and later recalls the ID to move to
that position.
"Del" : Use the button to delete preset ID.
"Set" : Save PTZ position information to preset ID.
"Menu" : Use the button to open the PTZ OSD menu.
"Enter " : Move to PTZ position set up for ID.
"Preset" : Use to save a PTZ position to Preset ID or move to a saved PTZ Preset ID.
1) Preset ID setting : ① move PTZ to a desired position → ② Click "Preset" button
2) Preset Run: ① Click "Preset" button → ② Input Preset ID → ③ Click "Enter" button
"Pattern" : Use to store multiple camera movements as one pattern sequence.
1) Pattern setting: ① Move PTZ to start position → ② Click "Pattern" button
→ ③ Input number (ID) to save → ④ Click "Set" button (Start position of pattern)
→ ⑤ Move PTZ in desired pattern → ⑥ Click "Set" button (At end position of pattern)
2) Pattern Run : ① Click "Pattern" button → ② Input Pattern ID → ③ Click "Enter" button
"Run Tour" : Use to start a tour of several presets in predefined order
1) Run Tour : ① Click "Run Tour" button → ② Click Touring ID to run → ③ Click "Enter" button
"Aux" : Use to turn on or off external device ( Wiper, Lamp, others) linked to PTZ or Receiver.
1) Aux On : ① Click "Aux" button → ② Click Aux ID → ③ Click "Set" button (On)
2) Aux Off : ① Click "Aux" button → ② Click Aux ID → ③ Click "Enter" button (Off)
7 SPOT : This function enables the user to set the selected PTZ camera to appear on the spot
monitor outputs.
"SPOT1" : This button transfers the PTZ camera picture to spot monitor 1 output.
"SPOT2" : This button transfers the PTZ camera picture to spot monitor 2 output.
☞ [Note]
☞
• To release the PTZ camera from the spot monitor output, click on the "Return"
button in the PTZ control menu or click on the spot button again.
• The camera will also be released from the spot monitor if another camera is
selected or if a screen split is selected that does not show the PTZ camera.
8
Return : Exit from the pan/tilt controls to the main display controls.
→ ③ Input number (ID) to save → ④ Click "Set" button
37
37