Status; Using Multiple Projectors - Christie Roadster S+14K-J User Manual

Section 3: Operation
HDMI OUTPUT LOOP SOURCE
Configure the HDMI output options.
Select Direct Loop to directly pass-through the HDMI input signals (from the same Twin HDMI Input Card).
The Input1 signal is looped to Output1 and the Input2 is looped to Output2.
Select Main/Secondary Loop to loop the Main & secondary video to the outputs (regardless of which card
these signal originate from). The Main video signal is looped to Output1 and the Secondary video signal is
looped to Output2.
Select Disable to shut off the HDMI outputs completely.
STANDBY ACTIVE LOOP-THROUGH
Enable this checkbox in situations where a Twin HDMI Input card is being used to loop signals out to another
projector. Standby Active Loop-Through ensures that video signals continue to be looped out when the
projector enters standby power mode.
Loop-Through is selected), limited channel control is available - inputs can be switched, perform auto setup
and some limited input settings can be modified.

3.11 Status

The read-only Status menu lists a variety of details about the standard and optional components currently
detected in the projector. Refer to the Status menu for versions of hardware and software installed, the type
(size) of lamp, the hours logged in total and for a specific period (such as a rental period), and for your
projector model name and serial number. In addition, the Status menu identifies the current channel, its
location, its frequencies and other details.

3.12 Using Multiple Projectors

IMPORTANT! When working with more than two projectors, work left to right, top to bottom.
When an installation requires multiple projectors, use the RS-232 serial ports to daisy chain the units together
and control the group with a single keypad or a computer/controller connected to the first projector. In such a
network, you can select to broadcast commands to the entire group, or use the P
responses to an individual projector.
Alternatively, you may want to add projectors to a hub on an Ethernet network. See
Network for full routing details.
Matching Colors in Multiple Screens
In a multiple-projector wall, you will likely want to precisely match color and intensity from image-to-image
so that the full wall is as uniform as possible.
3-54
: When the projector is in standby mode (and Standby Active
NOTE
key as desired to limit
ROJ
Figure 2-41 Mixed
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)