Installation Considerations - Christie Roadster S+14K-J User Manual

Section 2: Installation and Setup
• Zoom and Focus – There are two internal lens motors that allow for quick motorized adjustment of zoom
and focus. Adjust zoom to fit the displayed image on the screen and adjust focus to improve the clarity of the
image.
The projection lens is shipped separately from the projector.
NOTES: 1)
transporting the lens to avoid scratching and damaging the lens, which could affect your displayed image.
Motorized lenses should not be adjusted by hand without first setting them for manual operation, otherwise
the zoom and focus motors may be damaged. (Set in Menu>Configuration>Lens Settings>Manual
Zoom/Focus).
• Lens Offset – The motorized lens mount allows vertical and horizontal offset of the displayed image.
• Shutter – Standard on all models, the shutter allows you to turn the screen absolutely black when in the
"Closed" state.

2.2.2 Installation Considerations

Proper installation of your projector will ensure the quality of your display. Whether you are installing a
projector temporarily or permanently you should take the following into account to ensure your projector
performs optimally. Select the installation type that best suits your needs: front or rear screen, floor mount or
inverted mount.
Lifting, Hoisting, and Stacking
For any new installation, you will likely have to safety lift or hoist the projector into place. Keep in mind the
following guidelines for safety.
Lifting Guidelines
All models include handles for convenient hand transport only; such as when a projector is lifted from a
shipping container to a table.
Note the following:
• The handles are intended to support the weight of 1 projector only.
• The handles are intended to support a projector for a brief time only.
• The handles are not safety points; nor points from which to hoist or suspend the projector.
Hoisting Guidelines
There are 4 integral rigging points on the top of the projector to enable upright or inverted hoisting. See
2-12 For either orientation, hoist an individual projector, or up to 3 projectors in a stack.
2-10
1) The handles cannot support more than 1 projector. 2) Do not use handles for
extended time periods, 3) Do not use the handles as safety points, or as points from
which to suspend or hoist the projector.
Maximum stack = 3 projectors. Stack first, then hoist.
Use the lens cap when
2)
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)
3)
Figure