Connecting Sources - Christie Roadster S+14K-J User Manual

Section 2: Installation and Setup
2.4

Connecting Sources

Sources are connected to the Input Panel located at the back of the projector.
Input Panel allows one image processor board and up to 4 input cards to be inserted. The input cards are hot
swappable i.e. they may be plugged in and out while the projector is running. The image processor should only
be replaced when the projector is off or when it is in standby mode.
There are 6 option Input cards available:
• High-Definition Multimedia Interface/Twin HDMI (High-Definition Multimedia Interface)
• Analog BNC
• Dual 3G/SD/HD-SDI (Serial Digital Interface)
• Dual Link DVI
• Video Decoder
• DMX512 Interface
These cards slide into the option slots, shown in
slot. One or more of the option slots may be used with any combination of option cards, including multiples of
the same card type. There may be up to 2 active inputs being displayed at any time, either from one card or
from 2 cards. These 2 inputs can be routed to outputs or to the main or PIP video image.
Specifications for more details.
LEDS
LEDs are located on the faceplate of each input card and indicate the following:
• Power ON - Green
• Signal Valid - Green
• Signal Invalid - OFF
Twin HDMI Input Card
This card accepts one or two HDMI inputs, and can route one or both inputs to the card outputs. As a factory
default, the output labelled '2-OUT' loops out the image displayed in the picture in picture (PIP). Alternatively,
a Direct Loop can be enabled whereby the HDMI Input 1 signal loops to HDMI Output 1, and HDMI Input 2
loops to HDMI Output 2. See
card can be looped out of this card. There are 5 LEDs on the module faceplate. The PWR on the left side
indicates power is applied, and that the card is initialized. The LEDs to the right side of the corresponding
connectors indicate that a valid signal is detected. In the case of the outputs, the LED indicates a signal is
currently being looped out.
2-36
Figure 2-44 Input
Section 3.10 Input Switching & PIP
Figure 2-44 Input
Panel. The option cards can be used in any
NOTE:
Menu. Any input from any optional input
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)
Panel. The
See Section 7