Hoisting Procedure - Christie Roadster S+14K-J User Manual

Section 2: Installation and Setup
IMPORTANT! Remove the lens before hoisting the projector.

2.2.3 Hoisting Procedure

This procedure applies to one or more projectors. To hoist a stack, first
stack 2 or 3 projectors according to the stacking procedure included in
this manual. Never stack or hoist more than 3 projectors together.
1. Remove lens (recommended)
Remove the projection lens to prevent possible damage during
hoisting. Refer to
2. Retract feet.
If the projector is inverted, retract the adjustable feet to prevent the
hoisting hardware from getting caught.
3. Attach safety cables.
Attach a safety cable to each of the 2 eyebolts mounted on the
bottom of the projector. See
if non-inverted.
NOTE: When hoisting a non-inverted projector or stack, add 2 safety
eyebolts in the front and rear threaded holes provided on the
top of the projector. Ensure the eyebolts have an adequate rating for the load. Secure safety cabling to
both eyebolts.
2-12
F 2-14 NEVER
IGURE USE
5.2 Replacing the Projection
Figure 2-15. NOTE: Add eyebolts (2)
Always use at least 2 safety cables for any hoisting.
Attach safety cables to the 2 eyebolts.
H H
ANDLES FOR OISTING OR
Lens.
S P
AFETY OINTS
Figure 2-15 Attach Safety Cables
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)