Size And Position Menu - Christie Roadster S+14K-J User Manual

Section 3: Operation
From your presentation, you can access any of the individual options in these menus by pressing M
followed by the appropriate two-digit number representing their location in the menu system. For example,
press M
24 to quickly access the "Color Space" option in the Image Settings menu.
ENU
For certain options, preference may be to use a "direct key" from presentation level to go directly
NOTES: 1)
to a particular option without traveling through the menu system (available for certain display parameters
only). For example, press C
your presentation.
Preferences menu.
OSD then the D
For a good and efficient first step in perfecting the image, press the auto setup button, A
critical display parameters such as size, position, pixel tracking, etc., based on the type of incoming source. An
Auto Setup can save considerable setup time, and you can still adjust the image as described below.
The best auto setup will be obtained under the following conditions:
• Input levels, it is best to have an image with saturated (very Bright) colors.
• Phase, high contrast edges are needed.
To determine active window size:
• Video images should have whites and blacks in the image
• Wide range video images should have content (including white) that extends to all edges of the image.
When AUTO is pressed, the auto setup process shall begin. In some cases for analog video a menu may appear
that presents multiple choices that allows the user to select the format that best suits their source. This
selection helps the auto setup get the correct settings for the tracking and phase controls for analog sources that
contain the same number of active lines, but have a different aspect ratios.
• All digital and decoder option cards, will not present an additional auto setup menu since digital hardware
provides enough information to perform the correct auto setup.
• Analog PC graphics sources (4/5-wire sync) present a list of formats based on the current active lines
detected in the video.
• Analog Video Sources (3 wire sync on green) always have the options Default and Advanced. Video
sources use a look up table to determine their format based on video standards. The Advanced auto setup
selection measures the start pixel and start line whereas Default uses the table values as is.
3.6

Size and Position Menu

Increase or decrease the size of your image, change
its proportion (aspect ratio), move the image to a
specific area of the screen, and refine other related
parameters. Use Size and Position controls to
match the image precisely to the screen used at the
site.
Refer to Using Slide bars and Other Controls
you need help using any of the options and
controls. Changes made in the Size and Position
menu are applied immediately and are saved when
you exit the menu (press E
3-18
to access the "contrast" slide bar immediately. Press E
ONTRAST
To hide "direct" slide bars, disable the Display Slide bars check box in the Menu
2)
To hide the entire menu system from view, turn off the on-screen display by pressing
3)
A K
.
OWN RROW EY
or M
).
XIT ENU
if
F
IGURE
XIT
. This optimizes
UTO
3-17 S P
IZE AND OSITION
J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 (10-2011)
ENU
to return to