Orban Optimod-FM 8300 Operating Manual page 50

2-2
INSTALLATION
of purchase. Please fill in the Registration Card and send it to us today.
(The Registration Card is located after the cover page).
Customer names and information are confidential and are not sold to
anyone.
2. Check the line voltage, fuse and power cord.
DO NOT connect power to the unit yet!
A) Check the V
OLTAGE
The 8300 is shipped from the factory with the V
to the 230V position. Check and set the V
local voltage requirements. To change the operating voltage, set the
V S
OLTAGE ELECT
priate.
B) Install the proper fuse and fuse holder, per your country's standards.
The 8300 is shipped from the factory with the fuse, and fuse holder re-
moved. Select the appropriate fuse holder and fuse from the supplied
parts in the accessory kit. Use the gray fuse holder for domestic / 115V
operation, or the black fuse holder for European / 230V operation. For
safety, use ½-A-250V Slow-Blow for 115V, or 250mA-250V for 230V.
TYPE 18/3 SVT COR, TYP
(3 x .82 mm 2 )
PLUG FOR
115 VAC
(USA)
TYPE H05VV - F - 0.75
PLUG FOR
230 VAC
(EUROPEAN)
C) Check the power cord.
AC power passes through an IEC-standard mains connector and an RF fil-
ter designed to meet the standards of all international safety authorities.
The power cord is terminated in a "U-ground" plug (USA standard), or
CEE7 / 7 plug (Continental Europe), as appropriate to your 8300's Model
Number. The green / yellow wire is connected directly to the 8300 chassis.
switch. This is on the rear panel.
S
ELECT
to 115V (for 90-130V) or 230V (for 200-250V) as appro-
WIRE COLOR
CONDUCTOR
NORMAL
L
LINE BROWN
NEUTRAL
N BLUE
E
EARTH GND GREEN-YELLOW
CONDUCTOR WIRE COLOR
L
LINE
N NEUTRAL
E
EARTH GND GREEN-YELLOW
Figure 2-1: AC Line Cord Wire Standard
ORBAN MODEL 8300
S
OLTAGE ELECT
S switch to your
OLTAGE ELECT
ALT
BLACK
WHITE
GREEN
BROWN
BLUE
switch set