Receiving And Inspecting The System - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Receiving, Inspecting and Unpacking the
Wine Guardian System

Receiving and Inspecting the System

Wine Guardian systems are factory assembled and tested prior to shipment.
Wine Guardian systems are shipped individually in corrugated boxes specially designed to protect the
equipment during shipment.
√ Before opening the container, inspect the packing crates or boxes for obvious signs of
damage or mishandling.
√ Write any discrepancy or visual damage on the bill of lading before signing.
√ Inspect all equipment for any sign of damage caused during transit.
√ Report all visual or concealed damage to the carrier and file a claim immediately.
If this procedure is not followed, the shipping company may reject the claim
and the consignee may suffer the loss. Do not return the shipment to the
factory.
** DO NOT LIFT THE UNIT UP FROM ITS PLASTIC FRONT PIECES
The system should be lifted form underneath its base at both ends of the sys-
tem.
Review the Packing Slip to Verify:
√ Model number
√ Factory-installed options
√ System accessories
If any items listed on the packing slip do not match your order information, contact the place of
purchase immediately.
Check the unit for:
√ An electrical power cord (factory installed on condenser side)
√ The Through-the-Wall mounting sleeve
√ Accessories such as condenser air duct collar or duct collar kit, and op-
tional controls, if ordered
NOTE
IMPORTANT
TO AVOID DAMAGING THEM
3