Accessories And Optional Equipment - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Accessories and Optional Equipment

Installation Sleeve
Each Wine Guardian system includes an EasyMount installation sleeve to be used in the mounting of
TM
the system through-the-wall at the desired location. The sleeve is essential for the proper support of
the Wine Guardian system and ease of installation. The maximum dimensions of the wall opening
should be 14-1/2" wide by 16-1/4" high.
For proper operation of the system, including drainage and undue noise and vibration, the Installation
Sleeve must be mounted level within the wall cutout and securely fastened to the wall studs on either
side of the sleeve as shown on page 20.
Extended Compressor Warranty
The Wine Guardian uses only the best commercially available compressors on the market. However,
since the compressor is the single most expensive component in the system, it is recommended that
you purchase the extended, five-year warranty option.
Duct Collar Adapter
An optional duct collar kit is available for ease in directing the warm condenser air away from the
through-the-wall unit mounting. The kit includes one (1) duct collar, 15-feet of 6-inches round flexible
ductwork and two(2) tie wraps for connection of the ductwork to the duct collar. The kit does not
include connections at the tie-in point to the remote location or outdoors.
Remote Temperature/Humidity Controller
The remote temperature/humidity controller (Remote Interface Controller) is intended to provide a
means for user interface at a remote location. The controller can be used as a remote sensor/controller
mounted within the wine cellar remote from the Through-the-Wall system. The controller also can be
used as a remote controller (without sensor) or indicator mounted directly outside the wine cellar or in
another part of the residence or building. The Remote Interface Controller includes a backlit face for
temperature and humidity indication along with controller set-up and operational functions.
Remote Temperature/Humidity Sensor
The remote temperature/humidity sensor is intended to provide a means of sensing one or more
locations within the wine cellar and is designed to work in conjunction with the Remote Interface
Controller or Local Interface Controller integral to the Wine Guardian Through-the-Wall system. Mul-
tiple sensor readings are averaged and controlled to a single point. The sensors do not have any
temperature or humidity indication and must be mounted within the wine cellar area being controlled.
Humidity Option – An optional stand-alone humidifier comes fully assembled and tested for field
installation. It automatically adds moisture into the cellar by the evaporation of water over a distribution
pad.
8