Starting-Up And Operating The Wine Guardian - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Control Options and Wiring
Each Wine Guardian system comes with a control mounted on front of system. It is wired at the
factory for testing prior to shipment. Previously described in this manual.
Keep the thermostat guide in a folder along with the Wine Guardian Manual for future reference.
Remote Thermostat (Optional)
A phone cord-style communication cable is required to connect back to port supplied on the main
chassis. This may be factory supplied.
Mount the thermostat on a solid surface away from doors, corners, air outlets, drafts or heat generat-
ing equipment. Do not mount the thermostat directly on an outside wall or wall adjacent to a boiler
room. Use a piece of foam insulation behind the thermostat to insulate it from a hot or cold surface. The
recommended height is 4 feet to 5 feet above the floor.
Remote Temperature/Humidity Sensor
Previously described operation. This is also connected to the Wine Guardian chassis via a phone cord-
style cable, which may be factory supplied.
Starting-up and Operating the Wine
Guardian
Control Settings
The control has been wired and set up in the factory for testing with default settings. It is an
electronic digital thermostat for one-stage cooling. No additional adjustments should be
necessary except adjusting the cellar temperature to your preference. If additional adjustments
or changes are necessary, please refer to the configuration settings section in this manual.
Note
23