Priming The Drain Trap; Wiring The Unit For Power - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Priming the Drain Trap

The internal drain trap primes itself automatically once the unit has run for a period of time and after the
system cycles off. This is confirmed by water dripping from the drain.
Wiring the System for Power
The electrical outlet and wiring installation must meet the national and local building codes.
DO:
√ Match the electrical outlet to the plug provided on the Wine Guardian.
√ Provide dedicated circuit and wiring for the system.
√ Match the wiring and breaker size to the rated load as shown on the serial plate and in
this guide. See Sample Serial Plate illustration below.
DO NOT:
√ DO NOT MODIFY THE PLUGS IN ANY WAY!
√ Do not use extension cords.
The electrical power supply must be 115 volt AC 1 phase 60 cycle, depending on the
model of the system, and cannot vary more than +/- 4% or damage may occur to the
system.
Plug the system into the wall outlet. Gently pull on the plug to make sure it is tight.
WARNING
ELECTRICAL SHOCK HAZARD
IMPORTANT
21