Download Print this page

Wine Guardian Through-the-Wall Manual

Hide thumbs Also See for Through-the-Wall:

Wine Guardian® Through-the-Wall

How to Install Optional Duct Collars and Duct Work

Step 1 – Duct Collar and Ductwork Kit

1. Remove the two screws located at

the bottom of the condenser side

cover panel.

2. Pull the panel out and down away

from the Through-the-Wall (TTW)

assembly.

3. Place the panel on a soft surface,

a piece of foam or towel so as to not

mar or scratch the panel face.

4. Remove the four (4) screws, metal

brackets and clips as shown making

note of their location and orientation.

5. Remove the diffuser panel by

pushing the panel in from the face of

the cover panel.

Table of Contents

Need help?

Do you have a question about the Through-the-Wall and is the answer not in the manual?

Page 1 1. Remove the two screws located at the bottom of the condenser side cover panel. 2. Pull the panel out and down away from the Through-the-Wall (TTW) assembly. 3. Place the panel on a soft surface, a piece of foam or towel so as to not mar or scratch the panel face.
Page 2 Wine Guardian® Through-the-Wall How to Install Optional Duct Collars and Duct Work Step 1 – Continued 6. Insert the duct collar by carefully inserting the bottom tabs into the plastic slots located at the base of the opening as shown.
Page 3 Wine Guardian® Through-the-Wall How to Install Optional Duct Collars and Duct Work Step 2 – Duct Collar and Ductwork Kit 1. Pull back the outer layer of insulation and plastic sheathing from the flexible ductwork provided to expose the inner layer of 6”round ductwork.