Installation - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Installation

Pre-installation Test
Test the system before installing it to check for non-visible shipping damage.
To test the system:
√ Set the system on the floor or a sturdy level surface
√ Plug in the system
√ Press the on/off switch, control illuminates. This indicates the system has power.
√ √ √ √ √ The built in timer prevents short cycling and keeps the system from turning on
right away. The system comes on and runs as long as the temperature of the space is
above the thermostat set point. After several minutes, cold air comes out of the system
from the evaporator section side and hot air comes from the condenser
for any unusual noise or vibration.
Air Flow Illustration
SHARP EDGES
RISK OF SERIOUS INJURY
Sharp edges are present inside the Wine Guardian system.
CAUTION
section. Listen
15